Indux E300 Self-Contained Unit
The Indux E300 is a fully speed controllable heat recovery ventilation unit for through the wall installation. It extracts stale air whilst introducing warmed fresh air from outside. The E300 unit controls condensation and eliminates mould growth by effectively lowering internal relative humidity. Using a small dedicated speed controller (Sold Separately), switching to boost is easily achieved and using automated On/Off sensors/timers e.g. humidistat provides users the control to create the desired environment. In noise sensitive areas use an auto transformer controller. In the summer the user has the full control to remove the heat exchanger and replace with a plastic divider board to provide adequate cooling to rooms.
Three speeds; 75, 210 and 300m³/h
Speed Controller (Sold Separately)
Extension sleeve is available for walls up to 650mm thick
Controls indoor pollution, smoke, smells and dust mites
Saves waste heat and energy
Saves money on heating bills
The Indux E300 requires a hole of 380mm x 280mm and should be installed level and square in the wall. The self contained unit should also be fitted so that it overhangs by a minimum of 50mm on the inside and a minimum of 70mm on the outside.
The Indux E300 circulates warm outdoor air into the room and continuously extracts stale and moist air as well as smells. It provides a fresh environment where you can enjoy swimming for hours on end as the unit transfers heat from outgoing air to the fresh air supply without causing cross contamination. This helps users maintain the internal temperature and provides a comfortable and relaxing atmosphere.